Cable And Connector Protection - Avaya Advanced Gateway 2330 Regulatory Information

English
2. Locate the PVIM module. See the following figure for reference.
3. Release the latches that secure the PVIM in the slot. There is a release latch at both
4. Firmly grasp the edges of the PVIM and pull straight up to remove the PVIM from
5. If you are not installing a PVIM module at this time, replace the chassis top cover.

Cable and connector protection

The following practices prevent damage to cables and connectors:
• Use caution when connecting cables. Take care to ensure you insert each cable
connector in the correct port for the purpose you intend. For example, ensure you connect
LAN cables and connectors to LAN ports on the Advanced Gateway 2330.
• Support cables to prevent stress on the connectors. If you have a high-density cable
configuration, use an appropriate cable management system to relieve stress on the
cables. Also ensure that cables are threaded neatly, and that you employ cable ties as
required.
• Do not exceed the bend radius recommended for the type of cable installed.
• Fiber-optic cables and connectors require special care:
- Cover connectors with rubber safety plugs when they are not connected.
- Before you install or replace fiber-optic cables, clean the connectors.
- Do not exceed the bend radius that is recommended for fiber-optic cable. The
acceptable bend radius for fiber-optic cable is ten times its diameter, or 2.5 to 5 cm
(1 to 2 in.). If you use a radius of less than the recommended bend radius, a loss of
24 Regulatory Information
Voltage:
Do not open the Advanced Gateway 2330 top cover while the unit is powered.
ends of the PVIM slot.
the slot.
Comments? infodev@avaya.com
August 2013