Table of Contents
Advertisement
EPC-3221 CompactPCI
System Controller Board and C1XTN02 Transition I/O Module
®
Step 5: Power-On the System
Overview
After you have installed the EPC-3221 and optional C1XTN02 Rear Transition I/O Module
and attached the peripheral devices, connect all power cords and power-on the system.
No Power
If the system does not power-on, check all power connections and the power source.
If power connections are secure and the power source is adequate, contact Technical Support.
See
Customer Support
Startup
After you power-on the system, it will:
• Execute the Power-On Self Test (POST) to ensure that the system is functional and
properly configured
• Start the operating system
Setup
During the POST, you can access the Setup Utility
Figure 9. Setup Utility Main Menu
Main
Advanced
System Time:
System Date:
Legacy Diskette A:
Legacy Diskette B:
> Primary Master
> Primary Slave
> Secondary Master
> Secondary Slave
> Cache Memory
> Boot Options
> Keyboard Features
Extended Memory:
Memory Bank 0:
Memory Bank 1:
↑ ↓ Select Item
F1
Help
← → Select Menu
ESC Exit
20
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
on
page
vi.
Before using the SCB for the first time, you should verify the system settings in the Setup Utility.
See
page
21.
RadiSys CPD Setup Utility
Security
Power
[15:41:47]
[05/30/00]
[1.44/1.25 Mb
[Disabled]
[Maxtor 7541 A]
[None]
[LS-120 CSMO
[None]
63 MB
Not Installed
64MB SDRAM
-/+ Change Values
Enter Select > Sub-Menu
(Figure
9) to configure the system.
Boot
Server
Item Specific Help
3½"]
<Tab>, <Shift-Tab>, or
<Enter> selects field.
05]
F9
F10 Save and Exit
Exit
Setup Defaults
Service Manual
Advertisement
Table of Contents
