Table of Contents
Advertisement
Figure 5. Switch Block Location
Off
A Note on Crisis Recovery
Crisis recovery mode causes the system to boot from the floppy drive and re-flash the BIOS.
Note: Video is disabled on boot with crisis recovery mode enabled.
Before using crisis recovery mode, attempt to load the factory BIOS default values by
switching on SW1-3. Use crisis recovery mode only if the system will not boot otherwise.
RadiSys Corporation produces a utility to generate a crisis recovery diskette. This diskette is to
be used only with crisis recovery mode enabled. To acquire the proper release BIOS for this
product, contact RadiSys Technical Support (see
release BIOS of the utility, follow the instructions contained in the file README.TXT to
generate the diskette. The crisis recovery diskette must be generated on a system that is
operating MS-DOS
Service Manual
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
On
1-1
1-2
1-3
1-4
®
®
, Windows
95, Windows 98, Windows NT
Chapter 2: 6 Steps to Operation
page
vi). After downloading the proper
®
, or OS/2.
13
Advertisement
Table of Contents
