Step 3: Install The C1Xtn02 Transition I/O Module - RadiSys EPC-3221 C1000BX-SVE Service Manual

EPC-3221 CompactPCI System Controller Board and C1XTN02 Transition I/O Module
®

Step 3: Install the C1XTN02 Transition I/O Module

Overview
Before you connect any peripheral devices to the EPC-3221 System Controller Board, install
the C1XTN02 Rear Transition I/O Module onto a passive backplane in a chassis.
If the optional C1XTN02 Rear Transition I/O Module is not present in your computer system,
proceed to
Installing the Transition I/O Module
To install the C1XTN02 transition I/O module
1. Power-off the system and disconnect all power cords.
Note: Use a grounding wrist strap or other static-dissipating device when accessing and
handling the equipment.
2. Locate the system slot on the rear of the CompactPCI passive backplane. Use the slot
directly opposite from the SCB that was installed in Step 2 under
3. Unlock the injector/ejector levers on the transition I/O module panel (if required). Align
the edges of the transition I/O module with the card guide rails in the chassis subrack.
Make sure that both injector/ejector handles on the transition I/O module are in the open
position before attempting to insert the board.
4. Insert the transition I/O module into the chassis subrack with the card edges in the card
guide rails.
Note: The alignment pins on the transition I/O module panel will be inserted into the
alignment holes in the card guide rails.
5. Applying more pressure on the upper injector/ejector lever than the lower one, gently
insert the transition I/O module into the chassis subrack. Inspect the transition I/O module
faceplate to make sure it is fully seated.
6. Tighten the captive fasteners on the I/O panel to the subrack rails. (The captive fasteners
secure the transition I/O module in the chassis subrack.)
7. Connect peripheral devices. See
8. Reconnect all power cords and power-on the system.
16
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
RadiSys recommends installing the C1XTN02 Transition I/O Module onto a passive backplane
and with a system controller board manufactured by RadiSys. If installed in a non-RadiSys
backplane, consult the documentation provided by the backplane manufacturer.
Step 4: Attach Peripheral Devices.
Step 4: Attach Peripheral
(Figure 7):
Installing the
Devices.
SCB.
Service Manual