Figure 6. Installing The Scb - RadiSys EPC-3221 C1000BX-SVE Service Manual

Figure 6. Installing the SCB

Captive
Fasteners
(4 places)
Upper
Alignment Pins
Injector/Ejector
Levers
(Upper/Lower)
EPC-3221 System
Controller Board
(shown with optional
CPBRI01Bridge
Card installed)
Lower
Injector/Ejector
Levers
Step 2:
Simultaneously lock
the injector/ejector levers
on the I/O panel (2 places).
Refer to the more detailed SCB
installation instructions on
Service Manual
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Chassis Subrack
Step 3:
Tighten the captive
fasteners on the
I/O panel (4 places).
Step 1:
Insert the EPC-3221
into the chassis
subrack.
Alignment
Hole
(Upper/Lower)
Subrack Front
(Upper/Lower)
page 14.
Rails
Chapter 2: 6 Steps to Operation
CompactPCI
Passive
Backplane
Card Guide Rails
(Upper/Lower)
15