Signode SRC Series Operation, Parts And Safety Manual page 3

OPERATING INSTRUCTIONS
Stand to one side of the strap while tensioning. Make sure all bystanders are clear before proceeding.
1. Fully open the sealer handles and center the open jaws on the seal.
2. Bring the sealer handles completely together to assure a proper notch.
3. Remove the sealer and bend the loose strap sharply back on the seal. Several additional bends will result in a clean strap
break-off. If the width and gauge of the strap being used will not allow it to be bent, cut the strap supply as close to the seal as
possible using an approved strap cutter.
4. To avoid contact with the sharp end of the strap, retract strap end back into the strap dispenser.
Wear safety glasses which conform to ANSI Standard Z87.1 or EN 166.
Failure to follow the above could result in serious personal injury.
3