Do-It-Yourself Maintenance; Replacing The Oven Light - Thermador SCD302 Care And Use Manual

S Oven Care and Use Manual

REPLACING THE OVEN LIGHT

WARNINGS:
To prevent electrical shock and or personal
injury:
• Before replacing the light bulb, be
sure the electric power is turned off at
the circuit breaker.
• Do not operate the oven unless the light
cover is securely in position.
• Halogen bulbs get HOT instantly when
turned ON.
• Be sure the oven and light bulb are cool.
AVERTISSEMENTS:
Pour empêcher le choc électrique et/ou la
blessure personnelle:
• Avant de remplacer l'ampoule, soyez
certain l'interrupteur d'éclairage
automatique sur le cadre du four est
déprimé.
• Ne pas faire fonctionner le four sauf si la
couverture d'éclairage est solidement dans sa
place.
• L'ampoule d'Halogène ALLUMÉE de vient
CHAUDE immediatement.
• Soyez certain que le four et l'ampoule sont
frais.
CAUTION:
If the light cover is damaged or broken, do not use
the oven until a new cover is in place.
ATTENTION:
Si la couverture d'éclairage est endommagée, ou
cassée, ne pas utiliser le four jusqu' à une nouvelle
couverture est en place.

Do-It-Yourself Maintenance

The oven lights are located, on the left and right side
walls of the oven. The lights have a removable
lens cover and a halogen light bulb. The ceramic
light socket housing is not removable by the user.
• Replace bulb with a 12-Volt, 10-Watt Halogen
bulb only.
Before replacing bulbs, turn off oven circuit.
To replace Halogen Bulb:
1. Remove oven racks.
2. Slide the tip
of a table
knife blade
between oven
wall and the
center of the
side of the
protective
glass lens
cover.
3. Support the
glass lens cover with two fingers along the
bottom edge to prevent the cover from falling to
the bottom of the oven.
4. Gently twist the knife blade to loosen the glass
lens cover.
5. Remove the glass lens cover.
6. Remove the bulb by grasping and sliding the bulb
straight up until the two prongs have cleared the
ceramic holder.
7. Do not touch the glass of the new replacement
bulb with your fingers. It will cause the bulb to
fail when it first lights. Grasp the replacement
bulb with a clean paper towel or facial tissue with
the prongs facing down. Locate the two prongs
in the ceramic holder, gently poking until the two
prongs locate in the ceramic socket.
8. Press down to seat the bulb.
9. Snap the protective glass lens cover over the
bulb housing.
10. Turn on circuit breaker.
Page 30
Oven Maintenance
Lens Cover
Light Bulb
Light
Socket