Carrera CRR RACE-210 Instruction Manual page 44

Replacing Parts
1. take off the protective cap.
2. Press the unlocking buttons (5) and remove the shaving
foil frame.
3. Grasp the old cutting blades at both ends between thumb
and index finger and pull them carefully off the shaver.
4. take the new cutting blades at both ends between thumb
and index finger and push them into the white holding
device. Press the cutting blades completely and briefly
down once until they audibly lock into place.
5. Carefully press the new shaving foil frame into the shaving
head frame until it locks in place with an audible click.
wARNING! risk of lacerations!
to carefully detach both cutting blades from the white
plastic holding device, grasp the cutting blade at both
ends between thumb and index finger and pull it off
the plastic holding device.
CAuTION! When pulling off the
cutting blades, remember the
spring located between cutting
blade and white plastic holding
device. After removal of the cutting
blades, carefully put the appliance
aside to ensure that the spring will not fall out (see fig.).
44
Spring