Carrera CRR RACE-210 Instruction Manual page 34

If the device has fallen into water, pull out the wall
Q
power supply immediately, and only then remove the
device from the water. Do not use the device again,
but have it checked by a specialist.
If the device is used in a bathroom, the cord connect-
Q
ing the device to the mains power must be pulled
out after use, as the proximity of water represents a
hazard, even when the device is switched off.
Installation of a residual current device (FI/rCD) with
Q
a rated residual operating current of no more than 30
mA is recommended to provide additional protection.
Ask your electrician for advice. the installation should
only be carried out by a qualified electrician.
DANGER of electric shock
Do not operate the shaver if the shaver, the wall power
supply or the cable shows visible signs of damage or if
the shaver has been dropped.
Connect the cable to the shaver before plugging the
Q
wall power supply into a power point.
Only connect the wall power supply to a properly
Q
installed easy to access power point supplying voltage
matching the rating plate. the power point must still
be easily accessible after connection.
Ensure that the cable cannot be damaged by sharp
Q
edges or hot surfaces.
Ensure that the cable is not trapped or crushed.
Q
Always pull at the wall power supply and never pull on
Q
the cable when unplugging the wall power supply.
remove the wall power supply from the power point ...
Q
after each use,
...
... after each charging process,
34