Flow Diagram - Hans Grohe Talis E2 Series Instructions For Use/Assembly Instructions

U 6 6
Safety Notes
Gloves should be worn during installation to prevent
U
crushing and cutting injuries.
The shower system may only be used for bathing,
U
hygienic and body cleansing purposes.
The hot and cold supplies must be of equal pres-
U
sures.
Installation Instructions
• The fitting must be installed, flushed and tested after
the valid norms.
• The mixer can not used together with a continuous
flow water heater.
• Prior to installation, inspect the product for transport
damages.
After it has been installed, no transport or surface
damage will be honoured.
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Thermal disinfection:
anti-pollution function
The product is exclusively designed for drinking water!
4
English
max. 1 MPa
0,1 – 0,5 MPa
1,6 MPa
max. 80°C
65°C
max. 70°C / 4 min
Assembly see page 31
Symbol description
Do not use silicone containing acetic acid!
Adjustment
To adjust the hot water limiter on single lever
mixers, please see page 37. No adjustment
is necessary when using a continuous flow
water heater.
Dimensions (see page 34)

Flow diagram

(see page 36)

Rate of flow mixer

Rate of flow handshower
Operation (see page 42)
• Due to the design of the Bidette fittings,
a small amount of water will leak at the
outlet of the fitting when the hand shower
is running.
• Hansgrohe recommends not to use
as drinking water the first half liter of
water drawn in the morning or after a
prolonged period of non-use.
Cleaning
see enclosed brochure.
Spare parts (see page 38)
Special accessories
seal (article number 98996000) order as
an extra
Test certificate (see page 44)