John Louis Home 38373 Assembly Instructions Manual page 6

11. Line the inside bottom of L-Hook with level line on wall and mark hole
locations. Attach (2) L-Hooks to wall using #8 1-1/2" screws (Fig. 7.4).
Use supplied plastic wall anchors if no stud is present.
FIG. 7.4
12. Replace bottom (E) shelf
13. Secure bottom (E) shelf onto (D) Vertical Support Bar
Vertical Clips and L-Hooks using #4 1/2" screws.
Step 7 – Angle Bracket
Assembly
1. Select Angle bracket for placement at (F) location (refer to selected
configuration layout for location).
2. Place angle bracket square with shelf underside and back wall. Level
shelf (front to back) then mark hole location and mark line at the bottom
of Angle Bracket against wall (Fig. 8.0).
3. Install angle bracket using #8 3" screw. Use supplied plastic wall
anchors if no stud is available (Fig. 8.1).
FIG. 8.0
Step 8 – Tower Shelves Assembly
1. Select desired location for (E) shelves.
2. Attach L-Hooks to (D) Vertical Support Bars using #6 3/4" screws
3. Place shelf onto L-Hooks. Either top or bottom L-Hook screw hole may
be used.
4. Level shelf (front to back) and draw level line onto back closet wall at
bottom of shelf Fig. 9.0).
5. Remove shelf.
5
6.
7.
8.
Step 9 - Finishing
1.
2.
FIG. 8.1
Line the inside bottom of L-Hook with lower level line on wall and
mark hole locations. Attach (2) L-Hooks to wall using #8 1-1/2" screws
(Fig. 9.1). Use supplied plastic wall anchors if no stud is present.
FIG. 9.0
Replace shelf and secure using #4 1/2" screws (Fig.9.2).
Repeat for remaining (E) shelves.
FIG. 9.3
Insert Angle Bracket button caps into screw holes.
Use provided touch-up paint to finish any scratches incurred during
installation.
FIG. 9.1