Page 3
Measure required dimension. Mark & cut shelf. IMPORTANT - Read Before Assembly Assembly instructions are written for 8 ft. configuration A. All assembly processes are the same for each configuration EXCEPT for the order or locations of the assembly process. Use selected configuration for shelf locations.
Page 4
STEP 3 - Marking Measurements Locate the 3 main height locations for your configuration. Measure up & mark the 84 in. shelf location. Mark the 42 in. shelf location. Mark the 72 in. shelf location. 15. Long hang garment bar is cut to 2 ft. (If your closet is greater or less than 8 ft.
Page 5
Center the top screw hole of the shelf mounting L-clip hardware with the Secure Shelf End using #8 - 1 1/2in. screws (use wall anchor if no stud is level line & mark all hole locations. present) Secure L-clip to wall using #8 1 1/2 in. screws at hole locations (Use wall 10.
Page 6
STEP 6 - Installing Vertical Support Bars Select an angle bracket & insert a #8 3 in. screw into hole location. Position angle bracket under the top shelf at the open end. Place level on shelf & use angle bracket position to level shelf end (Ensure the bracket is square with shelf underside &...
Page 7
Secure using #8 1 1/2 in. screws (use wall anchors if no stud is present). Place bottom shelf into clips. Secure shelf to hardware using #4 3/4 in. screws. STEP 7 - Installing Bottom Shelf Insert bottom shelf (logo shelf) into vertical clips. Hold in position &...
Page 8
Align bracket under 2nd vertical support at top shelf. Line inside bottom of L-clip hardware with level line. Repeat angle bracket installation steps. Mark hole locations. 10. Secure using #8 1 1/2 in. screws (use wall anchors if no stud is present). 11.
STEP 10 - Extra Shelves Put your excess cuts back into your closet. Any material greater than 24 in. wide can be used as an additional shelf. Cut excess lengths to 24 in. wide to use as shelves & place where ever you choose.