John Louis Home 38373 Assembly Instructions Manual page 5

8. Place shelf onto L-Hooks and Shelf End Bracket.
9. Secure shelf to all L-Hooks using #4 1/2" screws (Fig. 5.4)/
10. Repeat process for each (A) shelf.
Step 5 – Angle Bracket
Assembly
1. Select Angle bracket for placement at (C) location (refer to selected
configuration layout for location).
2. Place angle bracket square with shelf underside and back wall. Level
shelf (front to back) then mark hole location and mark line at the bottom
of Angle Bracket against wall (Fig. 6.0).
3. Install angle bracket using #8 3" screw. Use supplied plastic wall
anchors if no stud is available (Fig. 6.1).
FIG. 6.0
Step 6 – Vertical Support Assembly
N O T E : N O T E : The remaining Wardrobe Bars N O T E :
N O T E : N O T E :
will be used as Vertical Support Bars
(Refer to selected configuration layout for Vertical Support
Clip & L-Hook placement)
1. To install Vertical Support Clips onto (D) remaining Vertical Support
Bars, place brackets at top and bottom hole location as shown (Fig. 7.0)
and secure onto Vertical Support Bars using #6 3/4" screw.
2. Position L-Hooks onto (D) Vertical Support Bars at locations provided
(Refer to selected configuration layout).
3. Secure L-Hooks using #6 3/4" screw in the top hole location. (Fig. 7.1).
FIG. 5.3
FIG. 5.4
FIG. 6.1
FIG. 7.0
4. Place ONE (D) Vertical Support Bar at location provided (Refer to
selected configuration layout). Flush bar side with shelf end and
secure Vertical Clip to top shelf using #4 1/2" screw.
NOTE: NOTE: Always place (D) Vertical Support Bar NOTE:
NOTE: NOTE:
located at shelf end into position first. All (A) Shelves
should align in (D) Vertical Support Bar L-Hooks
5. Plum (Vertical Level) (D) Vertical Support Bar and secure
L-Hooks into (A) shelves using #4 1/2" screw (Fig. 7.2).
FIG. 7.2
6. Place SECOND (D) Vertical Support Bar at location provided (Refer to
selected configuration layout - Measurement on guide is obtained
from outside edge of Vertical Support Bars).
7. Secure Vertical Clip to top shelf using #4 1/2" screw.
8. Plum and secure remaining (D) Vertical Support Bar L-hooks into (A)
shelves using #4 1/2" screw (Fig. 7.2).
9. Flush shelf ends and screw bottom (E) shelf onto vertical support clips.
10. Level shelf (front to back) and draw level line onto back wall at bottom
of shelf. (Fig. 7.3). Remove shelf.
FIG. 7.3
FIG. 7.1
4