Read Before Assembly - John Louis Home 38373 Assembly Instructions Manual

S C
TANDARD
A
SSEMBLY
Required Tools for Installation
PENCIL TAPE MEASURE
IMPORTANT IMPORTANT IMPORTANT
IMPORTANT IMPORTANT

Read Before Assembly

Read Before Assembly
Read Before Assembly Read Before Assembly Read Before Assembly
Shelf lengths and Wardrobe Bars may need to be cut
depending upon configuration desired. Please refer to
Fig. 1.0 for recommended cut location.
All cut shelf lengths are used in closet configura
tions supplied
Depending upon your closet dimensions, some cut
lengths may not be usable.
(Example: If you choose an 8ft. closet configura
tion and the width of your closet is 8ft. 4in., the
cut shelf length will be short 4in. It is
reccommended that if your closet is over 8ft. (96")
to choose a 10ft. configuration).
(Example: If you choose an 8ft. closet configura
tion and the width of your closet is 7ft. 6in., some
shelf lengths may need to be cut 6in. shorter in
length to fit closet dimensions).
VERIFY SHELF MEASUREMENTS
MEASURE - MARK - MEASURE AGAIN.
Chosen configuration may not require use of all
hardware or components supplied.
It is recommended to secure hardware into wall studs
for overall strength and stability of closet system.
If choosing a custom designed configuration, it is
recommended to draw design first on transparent
grid supplied.
If choosing a custom designed configuration, modifi
cations to the instructions provided will be neccesary.
S
LOSET YSTEM
I
NSTRUCTIONS
LEVEL SCREWDRIVER SAW
Step 1- Pre-Assembly
1. Choose your desired closet configuration from the options provided.
2. Draw your closet interior dimensions on the transparent grid overlay
enclosed.
3. Place transparent grid over your desired configuration.
READ IMPORTANT NOTES READ IMPORTANT NOTES READ IMPORTANT NOTES READ IMPORTANT NOTES READ IMPORTANT NOTES
4. Using the length measurements for the (A) shelves and (B) wardrobe
bars obtained from your selected configuration (refer to selected
configuration layout), measure and cut (A) shelves and (B) wardrobe
bars to length. (See Fig. 1.0 for recommended cut location). (Note:Cut
at center of line during shelf cut. If cut location lands on a shelf slat,
cut at the closest slat opening near line).
Step 2 - Shelf & Wardrobe Bar
Assembly
(Refer to selected configuration layout for Wardrobe Bar placement)
1. Line up (A) Shelf and (B) Wardrobe Bar end.
2. Place notched side of Bar Spacer onto the Wardrobe Bar side with holes
and shelf inside (Fig. 2.0)
A
3. Place Bar Spacer 4" from each Wardrobe Bar end and at Wardrobe Bar
center point (Refer to selected configuration guide for number of
Bar Spacers per Wardrobe Bar).
4. Screw into place using #8 1" screws (Fig 2.1).
5. Repeat for every (A) shelf
FIG. 2.1
FIG. 1.0
B
FIG. 2.0
Bar Spacer
2