Tools Required; Product Disassembly Process - HP ProCurve Switch 2524 Product End-Of-Life Disassembly Instructions

2.0 Tools Required

List the type and size of the tools that would typically be used to disassemble the product to a point where components
and materials requiring selective treatment can be removed.
Tool Description
Philips head screw driver
Plier that fit 26cm or greater opening

3.0 Product Disassembly Process

3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment:
1. Remove screws from top cover and remove cover.
2. Remove screws holding down the main mother board and power supply
3. Unplug connectors and remover power supply
4. Use pliers, twist caps > 25 cm off power supply board
5. Remove mother board
6. Remove fans
7.
8.
9.
10.
3.2 Optional Graphic. If the disassembly process is complex, insert a graphic illustration below to identify the items
contained in the product that require selective treatment (with descriptions and arrows identifying locations).
EL-MF877-00
Template Revision A
Tool Size (if
applicable)
small
small
Page 2