Table of Contents
Advertisement
Stepper Motor Demo Application
•
After the device connects, go to Run → Load → Load Program
BOOST-DRV8711 Hardware and Software Files folder that was downloaded from the tool folder.
Go into the Application subdirectory and then go into the GUI subdirectory. Select the
appProgram.out file (Application\BOOST-DRV8711_GUIvX.X\appProgram.out).
•
After a short delay, the appProgram.out file is loaded onto the MSP430G2553
•
Close CCS
5. Method 2: Flashing the project through CCS debugger
•
Open Code Composer Studio
•
Go to File → Import
8
BOOST-DRV8711
Figure 8. Connect Target Selection
Figure 9. Load Program Selection
Copyright © 2014, Texas Instruments Incorporated
www.ti.com
(Figure
9). Browse to the
SLVU967 – May 2014
Submit Documentation Feedback
Advertisement
Table of Contents
