Flush Mount Installation - Primex XR Levo Series Install Manual

Flush Mount Installation

Complete the steps below to install a Flush Mount Digital Clock/Timer to either a new or existing wall surface.
Supplied materials
(1) Flush Mount Junction Box. Material: ABS plastic, Color: black; UL listed (UL 50E 1st Ed; listing number E469550)
(1) Bezel: material - ABS plastic, color - black
(4) #10 Phillips Flat Head Screw
(4) Drywall Anchors
How to install a flush mount digital/clock timer
Complete the steps below to install a Flush Mount digital/clock timer.
1. Mount Flush Mount junction box.
New Wall Surface: mount the junction box to wall studs using four common drywall screws (not supplied). Remove the
l
applicable conduit knockout(s) for the incoming AC-power and the timer input (required for timer models only). Do not
remove knockouts that you will not be using.
Existing Wall Surface: cut a 14.4 inches (36.5 cm) wide x 5.8 inches (14.7 cm) high wall opening between two wall studs.
l
Securely mount the junction box to all studs using four common drywall screws (not supplied) at each of the corner locations.
Remove the applicable conduit knockout(s) for the incoming AC-power conduit and the timer input conduit (required for
timer models only). Do not remove knockouts that you will not be using.
3. Connect conduit connection(s) to the junction box.
NOTE
For timer models only, AC wiring is required to be located to the right side of the junction box divider and the timer input
to the left side.
4. New Wall Surface only: cut out a 14 inches (35.5 cm) wide x 5.25 inches (13.3 cm) high wall opening for placement of the
clock assembly. Trim opening if necessary.
5. Gently snap the Flush Mount bezel onto the front of the clock/timer.
6. Secure wiring and complete AC-power and timer input connections.
7. Insert clock assembly into wall opening.
8. Level clock assembly within wall opening and secure bezel to the wall surface using the four screws and anchors (supplied) at
each of the corner locations.
32