Dual Mount Installation - Primex XR Levo Series Install Manual

Dual Mount Installation

A Dual Mount Digital Clock/Timer consists of two single-sided digital clocks and a bracket kit. The kit contains a flange (piece
that mounts to ceiling or wall), a bracket (piece that bolts to flange and to which two clocks are mounted), and the hardware
necessary to complete the installation. Using the kit, you combine the two single-sided digital clocks to create a dual clock.
NOTE
The two clocks function independently of each other, requiring each clock's settings to be configured separately.
Kit components
Flange: mounts to ceiling or wall
l
Bracket: bolts to flange and to which two clocks are mounted
l
Hardware necessary to complete the installation
l
Materials required (not supplied)
One junction box
l
How to install Dual Mount Digital Clock/Timer
1. On the wall or ceiling, measure and drill holes with the correct spacing to mount the flange over the junction box.
2. Attach the flange to the wall or ceiling using the toggle anchors and the longer machine screws provided.
NOTE
If wall mounting to location outside of the junction box, break off or cut openings in flange to route power cords.
3. Attach the bracket to the flange using the shorter machine screws, nuts, and washers provided.
4. Wire clocks to main power, using cord retaining clips to dress wires.
5. Align the clock to the bracket hooks and hinges and snap into place.
Upon applying power to the digital clock/timer or when pressing the Reset button located in the setting panel, the clock initiates
its power up sequence as described below.
1. All 8 LED segments display 8's with a red dot on the bottom right of each of the two hour digits and one at the second or last
minute digit.
2. All LED segments display dashes and then dashes with a colon between the hours and minutes.
27