Configure Display Settings - Primex XR Levo Series Install Manual

Configure Display Settings

Levo Series Digital Clocks and Timers have a dip switch control panel that sets its display settings.
How to access setting panel
To change the factory default settings, from the back side of the clock remove the small rectangular access panel. Setting
changes can be made while the clock/timer is ON and changes will take effect within a few seconds.
NOTE
When power is first applied to the clock/timer or the reset button is pushed, a decimal point will flash for approximately
three minutes while its receiver is turned on to search for a Transmitter signal. If the clock does not receive valid time data
from the Transmitter for 3 days, the red colon on the clock will flash.
Set LED dimmer display
The LED display is set to 100% by factory default.
To dim the LED by 25%, set the OPTIONS, DIM switch 1 to the OFF position and DIM switch 2 to the ON position, as illustrated
below.
To dim the LED by 50%, set the OPTIONS, DIM switch 1 to the ON position and DIM switch 2 to the OFF position, as illustrated
below.
To dim the LED by 75%, set the OPTIONS, DIM switch 1 to the ON position and DIM switch 2 to the ON position, as illustrated
below.
14