Remote Antenna Installation - Primex XR Levo Series Install Manual

Remote Antenna Installation

Digital Clocks and Timers with a remote antenna are shipped from the factory with a BNC cable attached to the clock/timer
assembly. The remote antenna components are required to be assembled and mounted.
Remote antenna components
(1) Antenna
(1) Mounting bracket
(1) Straight connector (for standard, vertical mount)
(1) Right-angle connector (for horizontal mount)
(2) Screws for mounting bracket
OPTIONAL COMPONENTS
16.5 ft. (5 meter) cable extension with BNC adapter
l
How to assemble Remote Antenna
1. For vertical mount, connect the BNC cable adapter to the straight
connector. For horizontal mount, remove the straight connector
and connect the BNC cable adapter to right-angle connector. Push
the adapter onto the connector and turn connector 1/4 turn to lock
into place.
NOTE
Antenna is required to be in a vertical position.
2. Connect the antenna to the other end of connector.
3. Use the two screws to securely mount bracket to wall surface.
How to mount Remote Antenna
The length of the BNC cable can be increased by adding cables and adapters up to a maximum recommended length of 45 ft.
l
(13.7 meter). The cable can be placed in any position, but the antenna must be mounted vertically and away from metal
objects. Unless it is very close to the Transmitter, the powered clock will not set to the correct time without the remote antenna
connected.
36
XR Levo Series Digital Clocks/Timers Install Guide