Surface Mount Installation - Primex XR Levo Series Install Manual

Surface Mount Installation

Complete the instructions below to install a Levo Series Digital Clock/Timer directly to the surface of a wall.
NOTE
Most building codes prohibit the use of hard-wired power connections for devices that can be removed without tools.
Clock/timers mounted directly to a wall must have standard power plugs.
How to install
Mount the clock/timer directly to the wall with the two #10 screws and anchors (supplied). To determine the spacing of the
see "Tilt-Bracket and Surface Mount Mounting Dimensions" on page 1.
screws,
Upon applying power to the digital clock/timer or when pressing the Reset button located in the setting panel, the clock initiates
its power up sequence as described below.
1. All 8 LED segments display 8's with a red dot on the bottom right of each of the two hour digits and one at the second or last
minute digit.
2. All LED segments display dashes and then dashes with a colon between the hours and minutes.
3. Once the clock/timer receives a signal from the Transmitter, the LED segments display the time received from the
Transmitter's time source and a flashing red dot appears at the bottom right of the second hour digit for three minutes.
22
XR Levo Series Digital Clocks/Timers Install Guide