Led Indications During Easy Replacement - Avaya 3730 Manual

5. When the text "Please insert old phone in charger" is displayed, replace the new handset
with the old handset. The handset can either be switched on or off.
If the CR3 Charging Rack is used, the left charging slot must be used for both handsets.
The handset restarts and after a few seconds, the system displays a message "Saving
settings. Do not remove phone from charger". The charger LED changes to
slow orange flashing. It may take several minutes.
Important:
If the old handset cannot communicate with the charger, put the new handset in the
charger to restore its settings (the handset's IPDI). If this step is not performed, the new
handset must be sent for service. The settings of the old handset can be transferred to
the new handset by using PDM/Device Manager.
6. When the system displays the message "Please insert new phone in charger",
replace the old handset with the new handset.
The system displays the message "Restoring settings".
Important:
Do not remove the handset while the message "Restoring settings" is displayed.
7. When the system displays the message "Phone successfully replaced. Please
remove phone to restart.", remove the handset from the charger.
The handset automatically restarts.

LED indications during easy replacement

The following table shows the LED indications that are used for the charger during the easy
replacement procedure.
LED indication
Orange, flashing (1 000 ms on, 1 000 ms off)
Orange, flashing (100 ms on, 800 ms off)
Red, flashing (100 ms on, 800 ms off)
Red, flashing (900 ms on, 100 ms off)
July 2017 Using Avaya 3730 DECT handsets connected to Avaya Integral Enterprise Software
Description
File transfer during Easy Replacement.
"Change phone" indication during Easy
Replacement.
Error indication during Easy Replacement. Put back
old handset in charger.
Error during Easy Replacement. Service needed for
both handsets.
IEE 7.2
Comments on this document? infodev@avaya.com
Easy Replacement of Handset
63