Sagem myZ-5 Technical Documentation Manual page 90

myZ-5
This operation must be done after license SAGEM COMMUNICATION
7RROV
- Phillips screwdriver
- Soldering iron
- Plait to be unsolder
- Flat screwdriver
- Plectrum
- Gloves
3UHOLPLQDU\ RSHUDWLRQ
1. Remove the battery (
2. Remove the lower casing of mobile (
3. Remove the equipped electronic board (
5HPRYDO SURFHGXUH
1. Remove the vibrating device from its housing first with a plectrum.
1. Unsolder the vibrating device on the equipped electronic board and take care of the wiring sense (2).
3ODFHPHQW SURFHGXUH
1. Flux the place of the vibrating device and solder it on the equipped electronic board, respecting the
wiring sense.
1. Position the vibrating device in its housing.
)XUWKHU RSHUDWLRQV
1. Place the equipped electronic board (
2. Place the lower casing of mobile (
3. Place the battery (
Contents
5HPRYH DQG 3ODFH
7KH YLEUDWLQJ GHYLFH
Risk of the procedure:
•
•
•
•
Proc sheet 0 01 ).
Proc sheet 1 01
Proc Sheet 1 18
Proc Sheet 1 18
Proc sheet 1 01
Proc sheet 0 01 ).
Vibrating device

REF MTB DTS 9- Indice B - December 09 2005
Damage the equipped electronic board.
Oxide the equipped electronic board.
Reverse the vibrating device wiring.
Damage the vibrating device housing.
).
).
).
).

Proc Sheet 2 01
1/1
Page 5-31
Procedure
Proc 0 01
Proc 1 01
Proc 1 02
Proc 1 04
Proc 1 08
Proc 1 13
Proc 1 14
Proc 1 18
Proc 1 20
Proc 1 26
Proc 1 27
Proc 1 29
Proc 1 30
Proc 1 31
Proc 1 32
Proc 2 01
Proc 2 02
Proc 2 04
Proc 3 01
Proc 3 02
Proc 4 01
Symptom
Symp 01
Symp 02
Symp 03
Symp 04
Symp 05
Symp 06
Symp 07
Symp 08
Symp 09
Symp 10
Test
Test 01
Test 02
Test 03
Test 04
Test 05
Test 06
Test 07