Connection C - Electrical - Agilent Technologies TV 551 Navigator User Manual

17
Technical Information
TV 551/701 Controller Installation
Connection C – Electrical
Figure 57
The turbopump is connected to the controller through an 8-pin connector. Pins
B, C and D are the 3-phase supply to the motor, pin E is connected to the
pump ground, pins G and H are not connected, pins A and F reserved for
Agilent.
If the temperature sensor is disconnected, the pump will not start. To prevent
damage to the pump when the temperature exceeds 60 °C, the sensor
automatically cuts out the power supply.
TV 551/701 Navigator User Manual / 87-900-934-01 (P) 317/328