Assemble/Set Workpiece Supports; Assemble/Adjust Spark Protection; Screw Device On To Workbench; Fill Water Into The Water Tank - Parkside PNTS 250 C2 Translation Of The Original Instructions

GB NI
IE
Assemble/set work-
piece supports
1. Screw the workpiece supports (6) on to
the device.
To do this, use the screw (16), washer
(15), toothed washer (14) and star nut
(7) supplied.
2. Set the workpiece support (6) of the dry
grinding disc with the star grip nut (7)
so that the distance between the dry
grinding wheel (5) and the workpiece
support (6) must not exceed 2 mm.
Periodically readjust the workpiece
support in order to offset the wear
and tear of the grinding disc (dis-
tance max. 2 mm).
Assemble/adjust spark
protection
1. Screw the spark protection holder (18)
onto the protective hood (
this, use the adjusting screw (21) includ-
ing the snap ring and washer (20/19)
and the nut (17).
2. Adjust the spark protection holder (18)
with the aid of the adjusting screw (21):
The distance between the dry grinding
wheel ( 5) and the spark arrester
holder (18) must not exceed 2 mm.
Periodically readjust the spark pro-
tection in order to offset the wear
and tear of the grinding disc (dis-
tance max. 2 mm).
3. Fold down the spark arrester into work-
ing position. Loosen the adjusting nut
(3) and tilt the spark arrester to the de-
sired position.
Retighten the adjusting nut (3).
12
1. Remove the rubber foot (10) of the wa-
ter container.
2. Screw the device onto the flat work-
bench with 4 screws and nuts. Insert the
screws through the 4 bore holes (9) on
the base of the device.
1. Insert the rubber closure (11) into the
25). For drain opening of the water tank (13).
2. Fill water into the water tank (13) up to
the water level mark

Operation

- Always disconnect the plug from the
- Use only grinding discs and acces-
- Only use grinding tools which bear
Despite the spark protection, you
should always wear protective
glasses when working in order to
avoid eye injuries.
Screw device on to
workbench
The screws and nuts required for as-
sembly are not part of the scope of
delivery.
Fill water into the wa-
ter tank
Caution!
Risk of injury!
mains socket before working.
sories recommended by the manufac-
turer. The use of other insertion tools
and other accessories may cause risk
of injury.
information about the manufacturer,
type of binding, dimension and per-
mitted number of revolutions.
.