(4 or 8 ohm) or 70v/100v line speaker systems per channel. The amplifier can be mounted in a standard 19” equipment rack (rack ears supplied) or it can be used on a shelf or table. The ACM1202P features a line level input (with parallel output) per channel and is normally used with mixers, mixer amplifiers or other power amplifiers.
XLR Audio Input and Parallel Output The ACM1202P includes both male and female 3 pin XLR connectors per channel. While the female is normally used as the input to the amplifier, both XLR’s are connected in parallel so either will work. When signal is connected to one XLR, the other XLR becomes a line level output allowing the input signal to be distributed (split) to other amplifiers.
Page 4
Fuse Sizes Mains, 240VAC: 6 Amperes Slow Blow. Notes The DC fuse is located on the circuit board. This is a feature of the ACM series amplifier, which is equipped with a current limitting circuit preventing excessive DC current, thus eliminating the risk of blowing high tensions fuses. In the unlikely event that the DC fuse actuates, the output transistors should be checked, as it is probable that the amplifier has been subjected to very extreme conditions.
Do not parallel- or series-connect an amplifier output with any other amplifier output. Audio Telex Communications Pty Ltd is not respon- sible for damage to loudspeakers for any reason. 18. Do not ground any red (“hot”) terminal. Never connect a “hot”...
Page 6
Engineered by Audio Telex Communications Pty Ltd, Sydney, Australia Sydney (NSW & ACT Sales) Private Bag 149, Silverwater NSW 1811 149 Beaconsfield Street, Silverwater NSW 2128 Ph: (02) 9647 1411 Fax: (02) 9648 3698 E-mail: nsw@audiotelex.com.au Melbourne (Vic & Tas Sales) P.O.
Need help?
Do you have a question about the ACM1202P and is the answer not in the manual?
Questions and answers