7.8.3
Automatic Viewport function
About the Automatic function
When the automatic viewport function is selected, the reproduced image returns to the active area of the input signal.
Image 7-3
Viewport automatic
A
Actual viewport image
B
Automatic viewport to active area
Steps to be taken
1. Select Automatic. (menu 7-14)
2. Press ENTER to activate.
The image jumps to the active area within the input signal.
Viewport
Horizontal start
Width
Vertical start
Height
Total pixels
Automatic
Back
Menu 7-14
7.8.4
Total pixels setup
About total number of pixels
Enter the total number of pixels in regard with the total number of pixels in your source. When the total number of pixels is not correct
(small differentiation), artifacts in the form of dark bars will be visible in the image. The more visible bars in the image, the more is
the differentiation from the correct value.
Image 7-4
Total number of pixels
A
Image with wrong total number of pixels
B
Correct adjusted image
R5976672 SOLARIS LC40 01122003
7. Image Settings
43