Zanussi ZWI 71000 WA User Manual page 24

• a) Door
The dimensions of the door should be:
- width 595-598 mm
- thickness 16-22 mm
The height (C-Fig. C) depends on the height
of the adjacent furniture's base.
• b) Hinges
To mount the hinges it is necessary to drill
two holes (dia. 35 mm, depth 12.5-14 mm
depending on the depth of door furniture) on
the inner side of the door. The distance be-
tween the holes hobs fixing centres must be
416 mm.
The distance (B) from upper edge of the door
to the centre of the hole depends on the adja-
cent furniture's dimensions.
The required dimensions are given in the pic-
ture C.
The hinges will be fixed to the door by means
of screws for wood (2-Fig. B) supplied with
the appliance.
• c) Mounting the door
Fix the hinges (1) to the machine by means of
the M 5x15 screws (3-Fig. B). The hinges can
be adjusted to compensate for possible un-
even thickness of the door.
To align the door perfectly it is necessary to
loosen the screw (3-Fig. B), adjust the door
and tighten the screw again.
D
24
Caution! Do not remove the screw 8 !
d) Counter-magnet (6)
The appliance is prearranged for a magnetic
closure of the door.
To enable a correct operation of this device, it
is necessary to screw the counter-magnet (6)
(steel disk + rubber ring) into the inner side of
the door. Its position must correspond to the
magnet (4) on the appliance (see picture D).
4 5
E
Caution! Do not remove the screw 8 !
If the door has to be opened from left to right,
invert the position of the plates (7), the mag-
net (4) and the plate (5) (Fig. B and E). Mount
the counter-magnet (6) and the hinges (1) as
previously described.
4
6
8
6
1
7
3
2
8
www.zanussi.com