Zanussi ZWI 71000 WA User Manual page 12

You can change this value by pressing the cor-
responding button. The green pilot light of the
button 5 starts to flash.
The selector dial can be turned either clockwise
or counterclockwise. Turn to position
set programme/Switching the machine off.
At the end of the programme the selector
dial must be turned to position
switch the machine off.
Caution! If you turn the programme
selector dial to another programme when
the machine is working, the red pilot light of
button 5 will blink 3 times to indicate a wrong
selection. The machine will not perform the new
selected programme.
Select the spin speed or Rinse Hold
option by pressing button 2
The relevant light will light up.
When selecting a programme, the light corre-
sponding to the maximum speed allowed for
that programme will illuminate.
Select the available options by pressing
buttons 3 and 4
Depending on the programme, different func-
tions can be combined. These must be selected
after choosing the desired programme and be-
fore starting the programme.
When these buttons are pressed, the corre-
sponding pilot lights illuminate. When they are
pressed again, the pilot lights go out. If an incor-
rect option is selected, the integrated red pilot
light of the button 5 flashes for 3 times.
For the compatibility among the washing
programmes and the options see chapter
«Washing Programmes».
Select the Delay Start by pressing button
6
Before you start the programme, if you wish to
delay the start, press the button 6 repeatedly, to
select the desired delay. The relevant light illu-
minates.
You must select this option after you have set
the programme and before you start the pro-
gramme.
You can cancel or modify the delay time at any
moment, before you press button 5.
12
Selecting the delayed start:
1. Select the programme and the required op-
tions.
2. Select the delay start by pressing the but-
to re-
ton 6.
3. Press button 5:
– the machine starts its hourly countdown.
, to
– The programme will start after the selec-
ted delay has expired.
Cancelling the delayed start after having started
the programme:
1. Set the washing machine to PAUSE by
pressing button 5.
2. Press button 6 once, the light relevant to
the selected delay goes off
3. Press button 5 again to start the pro-
gramme.
The Delay Start can not be selected with
DRAIN programme.
Important! The selected delay can be changed
only after selecting the washing programme
again.
The door will be locked throughout the delay
time. If you need to open the door, you must set
the machine to PAUSE (by pressing the button
5) and then wait a few minutes. After you have
closed the door, press the button 5 again.
Start the programme by pressing button 5
To start the selected programme, press the but-
ton 5, the corresponding green pilot light stops
blinking. The pilot light corresponding to the
running phase illuminates. The appliance starts
operating and the door is locked.
To interrupt a programme which is running,
press the button 5: the corresponding green pi-
lot light starts blinking.
To restart the programme from the point at
which it was interrupted, press the button 5
again. If you have chosen a delayed start, the
machine will begin the countdown.
If an incorrect option is selected, the red pilot
light of the button 5 blinks 3 times.
Interrupting a programme
Press the button 5 to interrupt a programme
which is running, the corresponding green pilot
light starts blinking.
www.zanussi.com