Zanussi ZWI 71000 WA User Manual page 21

Unscrew the three
bolts with the sup-
plied spanner.
Fill the smaller upper hole and the two large
ones with the corresponding plastic plug caps
supplied in the bag containing the instruction
booklet.
Positioning
Install the machine on a flat hard floor. Make
sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that
the machine does not touch the wall or other
kitchen units.
www.zanussi.com
Slide out the relevant
plastic spacers.
Level the washing
machine by raising or
lowering the feet. The
feet may be tight to
adjust as they incor-
porate a self locking
nut, but the machine
MUST be level and
stable. If necessary,
check the setting with
a spirit level.
Accurate levelling prevents vibration, noise and
displacement of the machine during operation.
Caution! Never place cardboard, wood or
similar materials under the machine to
compensate for any unevenness in the floor.
After having levelled the appliance, tighten the
lock nuts.
Water inlet
Caution!
• This appliance must be connected
to a cold water supply.
• Before connecting up the appliance to
new pipework or to pipework that has
not been used for some time, run off a
reasonable amount of water to flush out
any debris that may have collected.
• Do not use the hose from your previous
appliance to connect to water supply.
The inlet hose is supplied with the appliance
and can be found inside the machine drum.
35°
Any necessary adjust-
ment can be made
with a spanner.
45°
21