Revolution 224854 User Instructions page 6

2.1. HANDLING AND UNPACKING
The packaging specifies the weight and volume of the appliance as well as guidelines concerning its handling
and storage.
2.2. PERSONNEL QUALIFICATIONS
The personnel handling the appliance do not need
to have any special qualifications to do so (consid-
er the type of the packaging). This should be done
2.3 CONDITION OF THE APPLIANCE
The appliance is supplied in a carton, placed on a
pallet. If supplied by our personnel, the appliance
2.4 HANDLING EQUIPMENT
The appliance may be lifted and moved by means
of a forklift truck, travelling crane, crane or other
device with an appropriate maximum working load.
Before starting the moving operation, check the
position of the fork and stability of the load. While
moving, always observe the following rules.
EN
• Move the appliance with due care
• Do not tilt the appliance, it must always be in the
2.5 STORAGE OF APPLIANCE
The surroundings of the oven should be dry, with
ambient temperature ranging from 0 °C to 40 °C.
Do not stack more packaged appliances than indi-
cated on the packaging and keep them upright as
2.6 SAFETY THERMAL BREAKER
THE MANUFACTURER AND THE SUPPLIER OF
THIS APPLIANCE DISCLAIM ANY LIABILITY FOR
ANY LOSS RESULTING FROM FAILURE TO OB-
SERVE THESE GUIDELINESS.
The appliance has a manually reset safety thermal
breaker which breaks the heating process when
6
by individuals who operate lifting equipment and
means of transport on a daily basis. Health and
safety regulations must be strictly observed.
may not be packaged otherwise.
vertical position.
• While moving, always monitor the transported
oven.
CAUTION:
Do not tip over the appliance.
Do not drag the appliance on the ground.
Do not cause any short circuits in the appliance.
indicated by the arrows. Make sure the fork does
not hit the appliance. In the event of accidental hit,
inspect the appliance for damage and if necessary
contact the manufacturer or the supplier.
the operating temperature exceeds the maximum
allowed temperature. To resume the operation of
the appliance, press the thermal breaker reset
button. This may only be done by qualified and au-
thorised service personnel.