Get Started; Connect Power; Install Battery; Set Clock - Philips PR702 User Manual

3

Get started

Always follow the instructions in this chapter in
sequence.

Connect power

Caution
Risk of product damage! Make sure that
•
the power voltage corresponds to the
voltage printed on the back or underside
of the clock radio.
Risk of electric shock! When you unplug
•
the AC adapter, always pull the plug from
the socket. Never pull the cord.
Risk of explosion! Keep the battery away
•
from heat, sunshine or fire. Never discard
battery in fire.
Danger of explosion if battery is incorrectly
•
replaced. Replace only with the same or
equivalent type.
Connect the power adapter to the wall outlet.

Install battery

You can only use AC power as power supply.
The AAA battery can only back up clock and
alarm settings. When power is disconnected,
the display backlight is off.
Caution
•
The battery contains chemical substances, so it
should be disposed of properly.
According to the instructions in the correct
polarity (+ / -) insert section 1.5V x 2 AAA
batteries (not provided)
Replace batteries when the Low battery
indicator is on

Set clock

1
In standby mode, press and hold SET TIME
for more than 2 seconds to activate clock
setting. The time format 24H on the display
will flash.
2
Press the - or + button repeatedly to select
24 hour (default) or 12 hour clock display
format.
3
press SET TIME to confirm and the hour
digits on the display will flash
AAA
EN 5