Contents 1 Important Safety 2 Your Bluetooth alarm clock with wireless phone charger Introduction What's in the box Overview of the Bluetooth alarm clock 3 Get started Connect Power Install battery Set clock Turn on Adjust display brightness 4 Set alarm timer Set alarm Activate/deactivate alarm timer 5 Set sleep timer...
1 Important Safety • This Bluetooth alarm clock shall not be exposed to dripping or splashing. • Don’t place any sources of danger on the Bluetooth alarm clock(e.g.liquid filled object, lighted candles). warning • Where the plug of the Direct Plug-in Adapter is used as the disconnect device, the disconnect device shall •...
2 Your Bluetooth alarm clock with wireless phone charger Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With this Bluetooth alarm clock, you can: •...
Overview of the Bluetooth alarm clock POWER/ • Bluetooth on/off - VOL + • Set hour and minutes • Set 12 hours or 24 hours • Volume up/down • Play/pause SNOOZE / BRIGHTNESS • Snooze the alarm • Adjust display brightness Display panel •...
Get started Caution • The battery contains chemical substances, so it should be disposed of properly. Always follow the instructions in this chapter in According to the instructions in the correct sequence. polarity (+ / -) insert section 1.5V x 2 AAA batteries (not provided) Connect power Caution...
Press the - or + button to adjust the hour (press and hold the buttons for rapid setting) Press SET TIME to confirm and the minutes digits on the display will flash Press the - or + button to adjust the minutes (press and hold the buttons for rapid setting) Press SET TIME to confirm and the set time is displayed.
Set alarm timer • Press ALARM1 or ALARM2 again to activate or deactivate the alarm timer. appears if the alarm timer is on and disappears if it is off. Set alarm • To stop the alarm, press the corresponding ALARM1 or ALARM2 buttons.
Set sleep timer The Bluetooth alarm clock can switch to standby mode automatically after a preset period. In Bluetooth playing mode, press SLEEP • repeatedly to select the sleep timer period (in minutes). To deactivate the sleep timer: In sleep timer setting mode, press SLEEP repeatedly until [OFF] appears.
Press POWER repeatedly to select Bluetooth mode on the display panel blink Activate the Bluetooth function in your Bluetooth device. Select “PHILIPS PR702” displayed on your device for pairing. If connection is successful, the Bluetooth alarm clock beeps twice and the icon stops flashing.
Charging Using Qi Wireless Charging This unit will wirelessly charge wireless charging compatible phones by placing your phone on top of the wireless charging icon of the Bluetooth alarm clock. The charging icon ( ) on the display is on while charging. USB charging port This product also has a USB charging port for devices that do not support wireless...
If you encounter problems when using this device, check the following points before requesting service. If the problem remains unsolved, go to the Philips Web page (www. philips.com/support). When you contact Philips, make sure that the device is nearby and the model number and serial number are available.
Directive 2014/53/EU. negative consequences for the environment and You can find the Declaration of Conformity human health. on www.philips.com/support. Removing the disposable batteries To remove the disposable batteries, see battery installation section. Care of the environment Environmental information All unnecessary packaging has been omitted.