Get Started; Install Batteries; Prepare The Remote Control; Connect Power - Philips DC390/11 User Manual

3 Get started

Caution
•
Use of controls or adjustments or
performance of procedures other than herein
may result in hazardous radiation exposure or
other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
bottom of the apparatus. Write the numbers
here:
Model No. __________________________
Serial No. ___________________________

Install batteries

Note
•
You can only use AC power as power supply.
Batteries (not supplied) are for backup
purpose.
2 x AA
2 x AA
1
Open the battery compartment.
2
Insert 2 x R6/UM-3/AA size batteries
with correct polarity (+/-) as indicated.
3
Close the battery compartment.
Caution
•
Remove battery if it is exhausted or will not be
used for a long time.
•
Batteries contain chemical substances, so they
should be disposed of properly.
•
Perchlorate Material-special handling may
apply. See www.dtsc.ca.gov/hazardouswaste/
perchlorate.

Prepare the remote control

Caution
•
Risk of explosion! Keep batteries away from
heat, sunshine, or fire. Never discard batteries
in fire.
1
Open the battery compartment.
2
Insert one button battery with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
Note
•
If you are not going to use the remote control
for a long time, remove the batteries.

Connect power

Caution
•
Risk of product damage! Ensure that the power
voltage corresponds to the voltage printed on
the back or underside of the apparatus.
•
Risk of electric shock! When you unplug the
AC power cord, always pull the plug from the
socket. Never pull the cord.
•
Before connecting the AC power cord, ensure
you have completed all other connections.
EN
11