Napa Carlyle DTW14FL Instruction Manual page 9

RESETTING PRESET VALUES
Torque Wrench comes with 9 Preset values
pre-installed at the factory.
To change a preset value stored in memory:
1. Press the memory button repeatedly to
access the preset value to be changed. (e.g. M5)
2. Press the button to change the units of
measure if required.
3. Use the UP/DOWN arrow buttons to
change the torque value.
Do one of the following:
A. Press the button to store the new value. The
torque wrench will stay at the new memory
location and will be ready for immediate use.
B. Press the button to go to the next memory
location in sequence. This is useful if you
are wanting to change/store multiple values.
If this warning appears, the wrench has applied more
than 110% of the torque set in memory.
SELECTING TRACK AND PEAK MODES
At start up either a (P) or (T) will show in the lower right
hand corner of the display depending on the last time the
wrench was used.
Note: Track (T) mode is the factory default.
1. In order to change the mode, press and hold the
button for 2 seconds.
Note: The display will briefly flash the "mode" screen.
2. Use the Up/Down buttons to toggle
between the Track (T) and Peak Hold (P) modes.
3. Press button four (4) times to exit mode setting.
DTW14FL
Pre-Set Memory Indicator: M1
Press
Pre-Set Memory Indicator: M2
Press
Pre-Set Memory Indicator: M3
Pre-Set Memory Indicator: M9
9
or for immediate use.
- M4,
- M5 . . . etc.
Rev. 12/11/14