Napa Carlyle DTW14FL Instruction Manual page 11

PEAK HOLD MODE (
Viewing Peak Hold Values:
1. Press and hold the
"nodE" appears in the display.
2. Press the button again and the display will
alternate between the last stored value and the
location to which it was assigned.
3. To display a different torque value stored in the
Peak Hold memory, use the
navigate to the desired location.
Deleting a Peak Hold Value:
1. Repeat steps above to view and navigate to the
location you wish to delete.
2. Press the button. "No?" appears in the display.
3. Press the button again. "dEL" appears in the
display and this action deletes the current entry.
4. The preceding memory location and torque value will
now alternate on the display.
Note: The display will automatically return to the
location that preceded the one deleted.
e.g. If location 15 (n015) was deleted from memory
the display would then show (n014) location 14.
When a stored value (location number) is removed from memory, the subsequent location numbers are reassigned. If
location 3 is deleted, the value that was in location 4 moves down one slot and becomes value 3. The value in location
5 moves to 4, etc.
Deleting all Peak Hold Values:
1. Repeat steps 1 - 3 above.
2. Press the button a third time.
"cLrA" appears in the display. This clears all stored
Peak Hold values from memory.
3. Press the button a fourth time.
"ConU" appears in the display allowing you to
continue to proceed to the next function you wish to
perform.
4. Press the button to return to the opening/start
display screen.
DTW14FL
.)
conT
button for 2-3 seconds.
buttons to
11 Rev. 12/11/14