Connecting Disk Drives To Hostraid Controllers; Connecting Directly To The Hostraid Controller - Adaptec 44300 Installation And User Manual

Connecting Disk Drives to HostRAID Controllers

You can connect SAS disk drives, SATA disk drives, or a combination of both to your
HostRAID controller. There are no jumpers or switches to set before installation.
If you plan to build a bootable array using internal disk drives, ensure you install at least the
minimum number disk drives required to support the RAID level you want. See
more information.
Note:
Although you can connect both SAS and SATA disk drives to your SAS controller,
Adaptec recommends that you not combine SAS and SATA disk drives within the same
array or logical drive. See
You have two connection options:
To connect directly to the controller, see
To connect to a backplane, see

Connecting Directly to the HostRAID Controller

In a direct-attach connection, SAS or SATA disk drives are connected directly to a SAS card
with SAS cables.The number of direct-attached disk drives is limited to four per internal SAS
connector. (For more information about direct-attach connections, see
Install your internal SAS or SATA disk drives, following the instructions in your system's
1
documentation.
Use internal SAS cables to attach the disk drives to the controller.
2
SATA disk drives attached to
controller with fan-out cable
External
SAS cable
When all internal disk drives have been installed and attached to the controller, close your
3
computer cabinet, reattach the power cord, then continue with
SAS Expander on page
Chapter 5: Installing the HostRAID Controller and Disk Drives
page 55 for more information.
page 25.
page 26.
External SAS connector
27.
25
page 58 for
page 56.)
Installing the Controller to a