Connecting Disk Drives To Your Controllers; Connecting Directly To The Controller - Adaptec 2258400-R Installation And User Manual

Thread the tie-backs through the slots on the
7
cap card and fix to the selected location on the
computer chassis. The tie-backs should
completely encircle the cap card to ensure that
it is held in place securely, as shown at right. Be
careful not to restrict air-flow through your
system.
Connect your computer's disk activity LED
8
cable to the LED connector on the controller (marked on the figures in
Controller on page
Ensure that the positive lead of the LED cable (usually a red wire or a wire marked with a
red stripe) is attached to pin 1.
Connect your RAID controller's I2C connector to an I2C connector on an internal
9
backplane or enclosure, using an I2C cable. For more connection details, see
RAID Controller on page
Prepare and install your internal disk drives, following the instructions in
10
Drives to Your Controllers on page
If you are not installing internal disk drives, close your computer cabinet, reattach the
power cord, then continue with

Connecting Disk Drives to Your Controllers

You can connect SAS disk drives, SATA disk drives, SATA Solid State Disk (SSD) drives or a
combination of all three to your SAS RAID controller. (See
for a list of compatible disk drives.) There are no jumpers or switches to set before installation.
If you plan to build a bootable array using internal disk drives, ensure you install at least the
minimum number disk drives required to support the RAID level you want. See
more information.
Note:
Although you can connect both SAS and SATA disk drives to your SAS controller, Adaptec
recommends that you not combine SAS and SATA disk drives within the same array or logical
drive. See page 66
You have two connection options:
To connect directly to the controller, see the following section.
●
To connect to a backplane, see
●

Connecting Directly to the Controller

In a direct-attach connection, SAS or SATA disk drives or SSDs are connected directly to a SAS
card with SAS cables.The number of direct-attached disk drives is limited to four per internal
SAS connector. (For more information about direct-attach connections, see
Install your internal SAS or SATA disk drives, following the instructions in your system's
1
documentation.
Chapter 5: Installing the Controller and Disk Drives
15).
15.
38.
Connecting External Devices on page
for more information.
page 39.
About Your RAID
About Your
Connecting Disk
40.
www.adaptec.com/compatibility
page 31
page 69.)
38
●
for