Surface-Mounted Installation - Miele KM 7564 FR Operating And Installation Instructions

Installation

Surface-mounted installation

 Create the worktop cut-out.
Remember to maintain the minimum
safety distances (see "Installation –
Safety distances").
 Seal the cut surfaces of wooden
worktops with a suitable sealant to
avoid swelling caused by moisture.
The sealant must be heat-resistant.
Make sure the sealant does not
come into contact with the top
surface of the worktop.
 Attach the sealing strip provided
underneath the edge of the cooktop.
Do not apply the sealing strip under
tension.

Risk of damage from incorrect
connection.
The electronics of the cooktop may
be damaged if a short-circuit occurs.
The mains connection cable must be
connected to the cooktop by a
qualified electrician.
 Connect the mains connection cable
by following the instructions in the
wiring diagram on the cooktop (see
"Installation – Electrical connection").
 Feed the mains connection cable
down through the worktop cut-out.
 Place the cooktop centrally in the
cut-out. When doing this make sure
that the seal of the appliance sits
flush with the worktop on all sides.
This is important to ensure an
effective seal with the worktop.
78
If the seal does not meet the worktop
correctly on the corners, the corner
radius (≤ R4) can be carefully scribed
to suit.
 Connect the cooktop to the electricity
supply (see "Installation – Electrical
connection").
 Check that the cooktop works.