Flush-Fit Installation - Miele KM 7564 FR Operating And Installation Instructions

Installation

Flush-fit installation

 Create the worktop cut-out.
Remember to maintain the minimum
safety distances (see "Installation –
Safety distances").
 Solid wood, tiled and glass worktops:
Fix a wooden frame 5.5 mm below
the top edge of the worktop.

Risk of damage from incorrect
connection.
The electronics of the cooktop may
be damaged if a short-circuit occurs.
The mains connection cable must be
connected to the cooktop by a
qualified electrician.
 Connect the mains connection cable
by following the instructions in the
wiring diagram on the cooktop (see
"Installation – Electrical connection").
 Attach the sealing strip provided
underneath the edge of the cooktop.
Do not apply the sealing strip under
tension.
 Feed the mains connection cable
down through the worktop cut-out.
 Centre the cooktop in the cut-out.
The gap between the ceramic surface
and the worktop must be at least
2 mm wide. This is required so that
the cooktop can be sealed.
 Connect the cooktop to the electricity
supply (see "Installation – Electrical
connection").
 Check that the cooktop works.
84
 Seal the gap between the cooktop
and worktop with a silicone sealant
that is heat-resistant to at least
160 °C.

Damage caused by unsuitable
sealant.
Unsuitable sealant can damage
natural stone.
For natural stone worktops and
natural stone tiles, only use silicone
sealant that is specially formulated
for natural stone. Please follow the
manufacturer's instructions.