Bgm Adapter; Connection To The Host Machine; Connection To The User System - Fujitsu MB95100 Series Application Note

MB2146-09 – Installation Guide
Chapter 3 Setting up the Emulation System

3.2 BGM Adapter

For details, refer the following manual:
• BGM Adapter MB2146-09 Operation Manual

3.2.1 Connection to the Host Machine

Connect the adapter to the host machine using the USB cable.
Figure 3: Connecting the USB Cable
If the BGM adapter is connected the first time to the host machine, it is possible the
operation system searches for a valid device driver. This driver can be found in your
Softune installation directory in subfolder [Drivers], for example "C:\Softune\Drivers\
SiUSBdB.inf".

3.2.2 Connection to the User System

Connect the adapter to the user system. Plug the user interface connector of the
adapter into the adapter interface connector on the user system.
When plugging the user interface connector, align its index mark (pin no. 1) with the
adapter interface connector's counterpart.
Figure 4: Connection to the User System
MCU-AN-395002-E-V10 - 8 - © Fujitsu Microelectronics Europe GmbH