Jumper Settings And Switches On Mcu Board - Fujitsu MB95100 Series Application Note

3.3.2 Jumper settings and switches on MCU board

Please set the following switches and jumpers on the MCU board
1. Set the clock selector switch (SW1-1) to OFF.
2. Set the clock supervisor selector switch (SW1-2) to OFF.
3. Set the APB8 bus output selector switch (SW1-3) to OFF.
4. Set the C-pin selector switch (SW1-4) to OFF.
5. Set the clock input selector switch (SW2) to OFF.
6. Set the product selector switch (SW3) according to table 2.
(set to 0: 100-pin package type for evaluation chip)
7. Set the LVD selector switch (SW4) to OFF (middle).
8. Set the power supply selector switch (SW5) to 3V or 5V.
9. Set the jumper plug S2 to LVD0 (right).
10. Set the jumper plug S1 (1+2) to CB.
11. Mount the main clock oscillator (refer chapter 3.3.3)
12. Mount the sub clock oscillator (refer chapter 3.3.3, not required)
6
1-4
12
Figure 7: switch and jumper setting on MCU board
© Fujitsu Microelectronics Europe GmbH
MB2146-09 – Installation Guide
Chapter 3 Setting up the Emulation System
9
- 11 -
8
7
5
11
10
MCU-AN-395002-E-V10