Integrated Peripherals - ECS 671T-M User Manual

Integrated Peripherals

This page sets up some parameters for peripheral devices connected to the system.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Onboard IDE Controller
SATA Mode Selection
USB Controller
Legacy USB Support
Onboard Audio DEVICE
OnBoard SiS191 Lan DEVICE
Onboard LAN Boot ROM
Serial Port1 Address
*Parallel Port Address
*Parallel Port Mode
*ECP Mode DMA Channel
*Parallel Port IRQ
: Move
F1:General Help
Onboard IDE Controller (Primary)
Use this item to enable or disable the onboard IDE interface.
SATA Mode Selection (IDE)
Use this item to select the mode of the Serial ATA.
USB Controller (Enabled)
This item enables the USB controller. Leave this at the default "Enabled" if you want to
connect USB devices to your computer.
Legacy USB Support (Enabled)
Use this item to enable or disable support for legacy USB devices. Setting to Auto allows the
system to detect the presence of USB device at startup. If detected, the USB controller
legacy mode is enabled. If no USB device is detected, the legacy USB support is disabled.
OnBoard Audio DEVICE (HDA DEVICE)
Use this item to enable or disable the onboard audio device.
OnBoard SiS191 Lan DEVICE (Enabled)
This item allows you to control the onboard SiS191 Lan device.
OnBoard LAN Boot ROM (Disabled)
Use this item to enable or disable the booting from the onboard LAN or a network add-in
card with a remote boot ROM installed.
Serial Port1 Address (3F8/IRQ4)
Use this item to enable or disable the onboard COM1/2 serial port, and to assign a port
address.
Parallel Port Address (378) (optional)
Use this item to enable or disable the onboard Parallel port, and to assign a port address.
Integrated Peripherals
Primary
IDE
Enabled
Enabled
HDA DEVICE
Enabled
Disabled
3F8/IRQ4
378
ECP
DMA3
IRQ7
Enter : Select
+/-/: Value F10: Save and Exit
F9: Optimized Defaults
Using BIOS
Help Item
DISABLED: disables the
integrated IDE Controller.
PRIMARY: enables only
the Primary IDE Controller.
ESC: Exit
35