Connecting To A Paired Bluetooth Device - Sony MDR-AS800BT Help Manual

3. Select [MDR-AS800BT].
If passkey (*) input is required on the display of the BLUETOOTH device, input "0000."
*
A Passkey may be called a "Passcode," a "PIN code," or a "Password."
4. Make the BLUETOOTH connection from the BLUETOOTH device.
Depending on the BLUETOOTH device, the headset may be connected with the device automatically as soon as
they are paired.
Note
If pairing is not established within about 5 minutes, pairing mode will be canceled and the headset will turn off. In
this case, start over from step 1.
When pairing with a BLUETOOTH device that cannot display a list of detected devices or that has no display, you
may pair the device by setting both the headset and the BLUETOOTH device to pairing mode. At this time, if
passkey is set other than "0000" on the BLUETOOTH device, pairing cannot be done with the headset.
Once BLUETOOTH devices are paired, there is no need to pair them again, except in the following cases:
Pairing information has been deleted after repair, etc.
The headset is already paired with 8 devices and another device is to be paired.
The headset can be paired with up to 8 devices. If a new device is paired after 8 devices are already paired, the paired
device with the oldest connection time is replaced by the new one.
When the pairing information for the headset has been deleted from the BLUETOOTH device.
When the headset is initialized, all pairing information is deleted.
The headset can be paired with multiple devices, but can only play music from one paired device at a time.
Hint
The above procedure is an example. For details, refer to the operating instructions supplied with your BLUETOOTH
device.
To delete all pairing information, see
Related Topic
How to make a wireless connection to BLUETOOTH devices

Connecting to a paired BLUETOOTH device

Listening to music from a device connected via BLUETOOTH
Disconnecting BLUETOOTH connection (after use)
Initializing the headset to restore factory settings
"Initializing the headset to restore factory settings."
Go to Page Top
80