Expanded System - Doro 430 Manual

English
General information about the expanded system (+1...)
When you purchased the telephone, the handset was pre-registered to the
accompanying base unit. The handset has the handset number 1, which is shown in the
display in standby mode. This number is also used for internal calls between handsets.
If you wish to use several handsets with one base unit, you should ensure that the base
unit is centrally positioned in order to evenly divide the base unit range among the
handsets.
You can:
- Register up to 6 handsets to one single base unit.
- Register up to 4 base units to one handset.
This model is also GAP (Generic Access Profile) compatible, which means that the
handset and the base unit can both be used with most other GAP-compatible units
irrespective of manufacturer. However, the GAP protocol does not guarantee all
functions will work.
Intercom
When using several handsets with the same base unit, calls can be made internally
between the handsets referred to as internal calls, or intercom. Intercom calls can only
be made between handsets connected to the same base unit.
1. Press Menu.
2. Scroll to INT Call using
3. Press All for a general call (to all handsets) or press the keypad button (
relating to the handset you wish to call.
Should an external call be received while an intercom call is in progress, a tone will be
heard. Press Accept to terminate the intercom and answer the incoming call.
Conference/Transferring calls between handsets
1. While an external call is connected.
2. Press Menu.
3. Scroll to INT Call using
4. Press All for a general call (to all handsets) or press the keypad button (
relating to the handset you wish to call.
5. Press Conf. to initiate a conference call, alternatively press
2

Expanded system

∧ ∨
/ . Press OK.
∧ ∨
/ . Press OK.
- )
1 6
- )
1 6
to transfer the call.
Q
www.doro.com