Charging; Prior To Operation - Hitachi R 18DSAL Handling Instructions Manual

English

CHARGING

For rechargeable batteries, please charge in according to the
handling instructions of the charger which you are using. (Fig. 5)

PRIOR TO OPERATION

1. Setting up and checking the work environment
Check if the work environment is suitable by following the precautions.
2. Mounting and dismounting the fi lter and pre fi lter
Before using the appliance, check that the fi lter is securely mounted.
(1) Remove the dust case (Fig. 6)
Looking at the dust case from the inlet port, turn it counterclockwise for approximately
120 degrees to align the protruding marks on the dust case and the housing, and then
pull it off .
(2) Remove the pre fi lter. (Fig. 7)
Turn the pre fi lter clockwise to remove it from the housing.
(3) Check the fi lter (Fig. 8)
After removing the pre fi lter, check to see if the fi lter is installed.
Also, check to see if the edges of the fi lter are turned up or not.
Protruding marks
Dust Case
Remove
Tighten
Inlet Port
Fig. 6
NOTE
If the fi lter is not properly fi tted, dirt or grime can enter the fan unit and cause damage or
malfunction.
Hold here
Pre Filter
Housing
1 Turn clockwise
Housing
2 Remove
Fig. 7
10
Battery
Charger
Fig. 5
Pre Filter
Filter
Fig. 8