How To Use - Hitachi R 18DSAL Handling Instructions Manual

(4) Install the fi lter (Fig. 9)
Fit the fi lter over the fi lter holder.
(5) Install the pre-fi lter (Fig. 10)
When installing the pre fi lter, press the
housing on with the projections in a horizontal
position. Then, turn the pre-fi lter until the
projections are fi xed in the grooves of the
housing.
(6) Install the dust case (Fig. 11)
Place the dust case over the housing, making
sure that the protruding marks on both are
aligned. Then, turn the dust case clockwise for
approximately 120 degrees.
Filter Holder
Filter
Fig. 9

HOW TO USE

WARNING
To prevent accidents when installing or removing the rechargeable battery, make
sure that the appliance is switched off .
CAUTION
○ Make sure that the rechargeable battery is
properly installed. If not properly installed, the
battery may fall out, causing injury.
○ Make sure the fi lter and pre fi lter is installed
when operating the appliance. Failure to do so
may result in injury or malfunction.
1. Verify the fi lter (Fig. 12)
Check to make sure the fi lter is installed.
Pre Filter
Projections
1 Push in Housing
Grooves
2 Turn to
secure
Hold here
Fig. 10
11
Protruding
Marks
1 Align the
protruding
marks
Dust Case
2 Turn clockwise for
Dust Case
Dust Case
* The dust case can also
be installed with the
nozzle facing upwards.
Fig. 11
Pre Filter
Filter
Fig. 12
English
Housing
approximately 120
degrees
Dust Case