Front Removal - Maytag Amana PTC A Series Service Instructions Manual

PROPER INSTALLATION
Wall Receptacle Within 58" From
Bottom Right Side Corner on
208/230 VAC Units Only
Wall Sleeve Dimensions
Outside Enclosure Panel Removal
The sleeve stiffener must be taken out before the enclosure
panel can be removed from the sleeve.
The enclosure panel can be removed by folding the four flaps
up and downward and manipulating the front ends of the top
plus bottom towards the center. The entire panel can be pulled
out diagonally from one side.
Install the wall sleeve condenser air grille by using the screws
and holes provided.
Installation (WS900B or WS900D)
After the wall opening is checked and approved for location,
size, and clearances, complete the following to install the wall
sleeve.
NOTE: Check with Amana
is installed in any wall sleeve not supplied by Goodman.
1. Remove the outside enclosure panel from the wall sleeve.
2. Slide the wall sleeve into the wall opening. Do not distort
the cabinet shape to fit the wall opening. The unit chassis
must fit snugly and uniformly into the wall sleeve.
3. Locate the sleeve within the range of minimum projections,
as shown in Minimum Wall Opening Dimensions and Mini-
mum Interior and Exterior Projections Figures, so both
sides are at least the minimum projection from the wall.
4. Check the level of the wall sleeve. For proper drainage, the
sleeve should be level from side to side and one-quarter
bubble in the sight glass sloping to the outside.
5. Two holes will need to be drilled in both sides of the wall
sleeve for mounting into the wall. Drill holes of proper size
and in the proper location so the screws will engage into
strong supporting members of the wall. DO NOT DRILL
THROUGH BOTTOM OF SLEEVE. The following figure
shows possible fastening methods.
18
® Technical Service when a chassis
Attaching Wall Sleeve to Opening
6. Check the level of the wall sleeve and adjust if necessary.
7. Caulk or seal around the outside of the entire sleeve.
8. If the unit chassis will not be installed immediately, re-
place the enclosure panel on the outside opening of the
sleeve. This will prevent weather damage to the building
interior.
9. Recycle or dispose of packaging materials per local codes.
OUTDOOR GRILLE
An outside grille must be installed to direct air flow for proper
unit operation and also protect the outdoor coil. The grille must
be installed before installing the chassis. Refer to the Installa-
tion Instructions supplied with the outdoor grille kit for a com-
plete description of the installation procedure.
This model requires either a Stamped Grille Kit (Model SGK--
B) or an Architectural Grille Kit (Model AGK--B). When replac-
ing an old chassis with an existing grille, please check with
your sales representative to determine if the new chassis should
be used with the old outdoor grille. An improper outdoor grille
can decrease cooling or heating capacity, increase energy
usage and shorten compressor life.

FRONT REMOVAL

1. Grasp the cabinet front as shown.
2. Pull the bottom of the cabinet front away from the chassis
until the retaining clips disengage.
Expansion
Anchor Bolt
Plastic
Anchor