Reset Ip Address; Connection - Bodet KELIO VISIO Instructions Manual

9.4 Reset IP address

• Launch the identification in the TEST module, then in Hardware control.
• Enter the Rst module (Reset).

9.5 Connection

There are three ways to see and test the connection between Kelio Visio and the server/computer:
• Perform a communication test in INSTALLATION > TERMINALS MENU > MAINTENANCE
> COMMUNICATION TEST > RUN
• Enter the work post number used to connect the reader in the browser address http://work
post number:8089/term-server/homepage
Ex http://4279b:8089/term-serveur/homepage click on « Go on On » to activate/deactivate the
connection of your hardware/terminals with the server
• Enter the INSTALLATION
FILTER
> TERMINAL SUPERVISION > HARDWARE STATE >
MENU
12