BYD S1 EV User Manual page 37

Tip
●
The anchor rod is installed in the gap between the seat cushion and the seat
backrest.
2. Lift up the head restraint, insert the top strap and grab of child seat between the head
restraint rods, and wind them to the back of backrest.
3. Open the anchor holder cover.
4. Fasten the hook to the anchor
holder and tighten the top seat to
ensure its fastening.
Hook
Anchor holder
Top belt
■
After the seat is installed, push/pull the child restraint device in different directions to
ensure that it is securely installed.
Warning
●
When using the lower anchoring device, ensure that there is no foreign object
around the anchoring device and that the seatbelt is not pinched behind the child
restraint device, to ensure that the child restraint device is securely fastened.
Otherwise, it may result in serious injury or even death in case of an emergency
braking or accident.
■
If the driver seat interferes with the correct installation of the child restraint device,
install the child restraint device in the rear right seat.
1-3 Child restraint device 37
1